-
Before Spray Foam Insulation and Prep.
-
The floors, fixtures, and outlets are protected before we begin installing Spray Foam.
-
The walls are prepared and our team has started to spray closed cell foam along the roof line.
-
It is always important for our teams to make sure they are wearing the proper safety gear to protect themselves from any off-gassing and over-spray. Once the foam cures, it does not off gas.
-
It takes even movements and patience to make sure we spray the correct thickness of the foam.
-
Closed Cell Spray Foam is installed between the joists on the ceiling. Fixtures were covered with Plastic to ensure we didn't get any over-spray on them.
-
The foam does not expand past the walls studs, allowing the homeowner to finish the shed with sheetrock.
-
Foam has been installed on the ceiling and walls. Now, it's time for the crew to clean up.
-
After the Install, our crew removes the plastic used to prep, and cleans up the shed to make sure it is just as clean as it was when we arrived.
-
Applying Spray Foam requires a skilled installer since the material expands as it is sprayed. They must take their time to ensure they don't overspray so it doesn't expand outside of the cavity.